Manual Front Disc Brake Conversion Kit for 1964.5-1966 Ford Mustang with 4-Piston Calipers
Ford Mustang
See what's included in your kit in the video below.
Check out this installation video from classismustangs429.
Looking for replacement parts for this item? Click Here
Description
Enhance your vehicle's safety, reliability, and performance with the LEED Brakes Manual Front Disc Brake Conversion Kit for 1964.5-1966 Ford Mustang featuring 4-piston calipers. This comprehensive drum to manual disc brake conversion kit includes everything you need to mount factory-style 4-piston disc brakes onto the original drum brake spindles of your classic Mustang. The kit is a direct bolt-on installation with no cutting, drilling, or welding required. All components are new, high-quality, precision-machined products, ensuring a great 1964.5-66 Mustang disc brake conversion with a factory look and easy installation!
Manual Front Disc Brake Conversion Kit Highlights:
Position: Front
Rotor Included: Yes
Rotor Style: Standard
Rotor Construction: Cast Iron
Rotor Diameter: 11.33 inches
Rotor Thickness: 0.812 inches
Caliper Included: Yes
Caliper Piston Quantity: 4
Caliper Material: Cast Iron
Caliper Finish: Zinc Plated
Caliper Piston Material: Stainless Steel
Minimum Recommended Wheel Diameter: 14x7 inches
Spindles Included: No
Master Cylinder Included: Yes
Brake Booster Included: No
Brake Lines Included: Yes
Quantity: Kit
Notes: Will fit most 14-inch Ford original disc brake wheels. Also fits 1967-1969 6-cylinder spindles but converts the vehicle to 5-lug.
Upgrade your classic Ford with the performance and reliability of LEED Brakes!
Take a tour of our Mustang Disc Brake Kit with the video below.
Click here to learn more about why LEED Brakes has added this warning to their products.
Details
- FC0001-405
- FC0001-405
- 887753629340
- LEED Brakes
- New
Shipping Information
- Item Requires Shipping
- 60.0 lbs.
- W12.0000” x H11.0000” x L12.0000”
Customer Reviews
Total Reviews (1)
You must login to post a review.
Reviewed by: Henry11/28/2017 02:13AM
Product ownership: Less than 1 week
Purchased from: LEED Brakes
Comments:
This is a nice competitively priced front disc brake kit. I did bend my front and rear brake lines to use the stock '66 distribution block and mount the proportioning valve body just below it. The supplied pre-bent 3/16 brake lines would fit. I did need a 3/16 plug for the original rear brake outlet of the distribution block and a 3/16 female to 1/4 male into the distribution block where the original single input from the master cylinder entered in the front of the distribution block.
The challange was getting the right torque to loosen the existing 51 year old brake fittings. Once the master cylinder was plumbed the hard work was essentially over.
The front drums can be removed without taking them apart by undoing the brake line in the wheel well and undoing the four bolts securing the drum to the front axle hub. Don't forget to remove the bearing race nut and cotter pin.
We did each step to both front hubs with the car on four jack stands. Each step was done twice and went quickly. After several trips to the local NAPA parts store we realized the supplied (attached to the flexible brake lines) unions could have been used on the 1/4 inch distribution block input to adapt the 3/16 inch line from the front output (rear port) of the master cylinder.
All told this is a good kit at an attractive price. The instructions are OK, but some adult supervision was appreciated.